Average Atomic Mass from Isotopes Calculator

Average Atomic Mass from Isotope Masses and Abundances

Give up to three isotopes with their masses and their percentage abundances and get the weighted mean — the number printed under the element’s symbol in the periodic table. The diagram shows why that number is almost never a whole number, and why it sits nearer the common isotope than the rare one.

Weighted mean of up to three isotopes

isotope masses and abundances give the atomic weight
The mass of one atom of this isotope in unified atomic mass units, u. It is NOT the mass number: chlorine-35 has mass number 35 but an atomic mass of 34.968853 u, because binding energy makes a bound nucleus lighter than its loose parts. Mass numbers are whole by definition, atomic masses never are — except carbon-12, which is exactly 12 because it defines the unit.
The percentage of atoms of this element that are this isotope — a number of atoms, not a mass. The three abundances do not have to add up to 100: if they do not, the page divides by whatever they do add up to, so you can enter a raw count of 7576 and 2424 atoms and get the same answer.
The second isotope’s atomic mass in u. Order does not matter; the arithmetic is symmetric. If your question gives mass numbers only, using 35 and 37 instead of 34.968853 and 36.965903 will still land within 0.03 of the right answer, which is usually inside the tolerance of a school marking scheme.
The second isotope’s abundance. For chlorine it is 24.24 per cent, and that single number is why the periodic table says 35.45 rather than 35 or 37.
A third isotope, if the element has one. Leave BOTH this and the abundance below it at zero if your element has only two isotopes — the page then ignores this row entirely. Magnesium, silicon, oxygen, potassium and neon all need all three rows.
Leave this at zero for a two-isotope element. An abundance of zero removes the isotope from the calculation whatever mass you typed beside it.
Each isotope is a bar standing at its own mass, and the height of the bar is the share of the sample that isotope makes up. The red arrow is the weighted mean — the number the periodic table prints — and the grey dashed line is the plain average of the masses with the abundances ignored. The red arrow always sits closer to the tall bar than the grey line does, and that gap is the whole point of the word weighted. Change an abundance and watch the red arrow slide towards whichever isotope you made commoner.
35.4529uExample

Chlorine: 34.968853 u at 75.76 per cent and 36.965903 u at 24.24 per cent

Advertisement

One weighted mean, and the two ways it goes wrong

Ar = (m1f1 + m2f2 + m3f3) ÷ (f1 + f2 + f3)  ·  with percentages, Ar = Σ(m×%) / 100
m
the atomic mass of one isotope, in u. Not its mass number. Chlorine-35 is 34.968853 u, and the 0.031 u missing is binding energy: the nucleus weighs less than the protons and neutrons it is made of
f
the abundance, as a count of atoms out of every hundred. It is an ATOM fraction, never a mass fraction, and mixing the two is the commonest conceptual error on this topic
the division
by 100 if your abundances are percentages that total 100, or by their own total if they do not. This page always divides by the total it is given, so raw atom counts work as well as percentages
Aᵣ
the relative atomic mass, or atomic weight. It is dimensionless by definition — a ratio against one twelfth of a carbon-12 atom — which is why the periodic table prints 35.45 with no unit. This page labels it u because the number is the same either way and u is what the isotope masses were entered in

Worked example

Chlorine: 34.968853 u at 75.76 per cent and 36.965903 u at 24.24 per cent
TURN THE PERCENTAGES INTO FRACTIONS. 75.76 per cent becomes 0.7576 and 24.24 per cent becomes 0.2424. They add to 1.0000, which is the check that you have the whole element and not part of it.
WEIGHT THE FIRST ISOTOPE. 34.968853 × 0.7576 = 26.4924 u. This is not the mass of anything; it is chlorine-35's share of the average.
WEIGHT THE SECOND. 36.965903 × 0.2424 = 8.9605 u.
ADD THEM. 26.4924 + 8.9605 = 35.4529 u, which is what the periodic table rounds to 35.45.
SANITY-CHECK THE POSITION. The answer must land between 34.97 and 36.97, and nearer the commoner isotope. It is 0.48 u above chlorine-35 and 1.51 u below chlorine-37, a ratio of about 1 to 3 — the mirror image of the 3 to 1 abundance ratio. If your answer is nearer the rare isotope you have swapped the two abundances, and if it is outside the range altogether you have multiplied instead of weighting.
WHY NOT 36? The plain average of 34.97 and 36.97 is 35.97, and the calculator prints that too, so you can see the difference the abundances make: 0.51 u, which is more than the whole gap between magnesium and aluminium. An average that ignores abundance is not a rounding error, it is a different quantity.
Advertisement

Five elements, and what their isotopes do to the average

ElementIsotopes and abundancesWeighted meanWhat makes it interesting
Chlorine34.968853 u at 75.76%, 36.965903 u at 24.24%35.4529 uThe standard example. The answer is nowhere near a whole number and that is not an error.
Boron10.012937 u at 19.9%, 11.009305 u at 80.1%10.8110 uThe rare isotope is the LIGHT one here, so the mean sits high in the range rather than low.
Copper62.929598 u at 69.15%, 64.927790 u at 30.85%63.5460 uA 69:31 split that lands almost exactly halfway between 63 and 64, which is why copper’s atomic weight looks like a deliberate half.
Magnesium23.985042 u at 78.99%, 24.985837 u at 10.00%, 25.982593 u at 11.01%24.3050 uThree isotopes, and the two heavy ones nearly cancel each other’s effect against the dominant light one.
Fluorine18.998403 u at 100%18.9984 uMonoisotopic. There is no average to take, and its atomic weight is known to eight figures as a result.
Isotope masses are from the AME2020 evaluation and abundances from the CIAAW 2021 tables; both are cited below. The abundances are representative values for terrestrial material, and for several elements — chlorine among them — CIAAW publishes a RANGE rather than a single figure, because different rocks and different oceans genuinely differ. The weighted means in the third column are this page’s own output at those inputs.

The three ways this calculation is set wrong in exams

What the question gives youWhat to doThe trap
Two masses and one abundanceThe other abundance is 100 minus the one you were given.Writing both abundances as the number you were given. The two must add to 100 for a two-isotope element.
The average and one isotope’s abundance, asking for a massRearrange: m₂ = (Aᵣ − m₁f₁) ÷ f₂.Dividing by the wrong fraction. Use the fraction belonging to the mass you are solving for.
The average and both masses, asking for the abundancesLet the first fraction be x, the second (1 − x), solve the single linear equation.Forgetting that the two fractions are not independent. There is one unknown here, not two.
All three are the same equation read in a different direction, which is worth noticing before an exam rather than during one. This calculator only runs it forwards; the reverse questions are a line of algebra from the same formula.

Why the periodic table almost never prints a whole number

Pick up a periodic table and look at chlorine: 35.45. There is no chlorine atom anywhere in the universe with a mass of 35.45 u. Every chlorine atom is either chlorine-35, at 34.968853 u, or chlorine-37, at 36.965903 u. The 35.45 is a bookkeeping number — the average mass of an atom in a sample of ordinary chlorine, weighted by how common each isotope is.

That matters because it is the mass chemistry actually uses. When you weigh out 35.45 g of chlorine atoms you get Avogadro’s number of them, three quarters light and one quarter heavy, and no reaction you run can tell the difference. The isotopes are chemically identical: same proton number, same electron count, same bonding. Only the neutron count differs, and neutrons do not take part in chemistry.

The arithmetic is a weighted mean and nothing more, but two things about it catch people out. The first is that the abundances are fractions of the ATOMS, not of the mass. If a sample is 75.76 per cent chlorine-35 by atom count it is slightly less than that by mass, because the heavy isotope contributes more mass per atom. School questions always mean atom fractions; say so in your working and you will never confuse the two.

The second is the pull of the common isotope. The weighted mean does not sit in the middle of the range — it sits near whichever isotope dominates, and the diagram above draws exactly that. For chlorine the mean is 0.48 u above the light isotope and 1.51 u below the heavy one. For boron, where the heavy isotope is the common one, the mean sits high instead. Sliding an abundance in the calculator and watching the red arrow move is the quickest way to make that stick.

One honest caveat. A tabulated atomic weight is only as fixed as the isotopic composition it comes from, and for several elements that composition varies from sample to sample. IUPAC’s own table gives chlorine as an interval, 35.446 to 35.457, and has stopped publishing a single atomic weight for lead altogether, because lead’s composition depends on how much uranium decayed in the rock it came from. Sulfur, boron and oxygen vary enough that the variation is used to trace where a sample came from. The number on your periodic table is a convention, chosen to be useful for ordinary chemistry, and not a constant of nature.

If you want the nuclear side of why these masses are not whole numbers in the first place, the mass defect and binding energy are physics rather than chemistry and live on the nuclear binding energy per nucleon calculator. For the particle counts behind each isotope, the isotope notation and particle count page does protons, neutrons and electrons from the mass number and the charge.

Frequently asked questions

Why is the relative atomic mass of chlorine 35.5 and not 35 or 37?

Because natural chlorine is a mixture: 75.76 per cent chlorine-35 and 24.24 per cent chlorine-37. The weighted mean of 34.968853 and 36.965903 with those abundances is 35.4529 u, which rounds to the 35.45 your data book prints. No individual atom has that mass. It is the average mass per atom of a normal sample, and it is the mass a mole calculation needs.

Do I use mass numbers or atomic masses?

Atomic masses, if you have them. Using the mass numbers 35 and 37 for chlorine gives 35.4848 instead of 35.4529 — out by 0.032, which is usually within a marking tolerance but is wrong in the third figure. Most exam questions hand you the atomic masses precisely so that you use them. Mass numbers are whole by definition; atomic masses are measured, and only carbon-12 is a whole number, because it defines the unit.

What if the abundances do not add up to 100?

Divide by whatever they do add up to. This page always does that, so you can enter raw counts — 7576 atoms of one and 2424 of the other — and get the same answer as from percentages. If a question gives you abundances that total 99.9, that is rounding in the source data, not a mistake you need to fix.

Can I work backwards from the average to an abundance?

Yes, and it is a standard exam question. For two isotopes, call the first fraction x and the second (1 − x), then solve m₁x + m₂(1 − x) = Aᵣ for x. There is only one unknown, because the two fractions must add to one. This calculator runs the sum forwards only, but you can get the same answer by typing abundances until the headline matches the average you were given.

Why is an atomic mass never quite a whole number of mass units?

Two reasons stacked on top of each other. A proton is 1.007276 u and a neutron 1.008665 u, so neither is exactly 1 u; and a bound nucleus is LIGHTER than its separate parts, because the binding energy was released when it formed. Chlorine-35 weighs 34.968853 u against 35.289 u for seventeen free protons, eighteen free neutrons and seventeen electrons — a deficit of 0.32 u, which is the binding energy of the nucleus in disguise.

Does the page work for an element with more than three isotopes?

Not directly, and that is a real limit: tin has ten stable isotopes and this page has three rows. For more than three, group the small ones: add their abundances together and use an abundance-weighted mass for the group, which costs almost nothing in accuracy because they are small by definition. Nothing about the method changes — a weighted mean of a weighted mean is still a weighted mean.

Related calculators

References

  1. Atomic Weights of the Elements 2021 and the Isotopic Compositions of the Elements 2021 tables, IUPAC Commission on Isotopic Abundances and Atomic Weights (CIAAW), read 14 November 2026 from ciaaw.org. CIAAW is the body that decides what number the periodic table prints. Two things on those tables surprise most students. The atomic weight of chlorine is published as the interval 35.446 to 35.457 rather than a single number, because the isotopic composition of chlorine genuinely differs between a seawater sample and a rock sample; the conventional value 35.45 is a compromise, not a measurement. And lead has no normal atomic weight at all any more, because its composition depends on how much uranium and thorium decayed nearby.
  2. The AME 2020 atomic mass evaluation, W. J. Huang, M. Wang, F. G. Kondev, G. Audi and S. Naimi, Chinese Physics C 45 (2021) 030002, with the companion NUBASE2020 evaluation at 030001. This is where nuclide masses come from: a least-squares evaluation of thousands of measured mass differences, quoted in micro-u. The masses used on this page are its values rounded to six decimal places, which is far finer than any school question needs and is quoted so that the arithmetic can be checked rather than taken on faith.
  3. CODATA Internationally Recommended 2022 Values of the Fundamental Physical Constants, NIST Standard Reference Database 121, read 14 November 2026. The elementary charge is exactly 1.602176634×10−19 C and the unified atomic mass unit is 1.660 539 068 92(52)×10−27 kg; the first has no uncertainty because the 2019 revision of the SI defines the ampere through it. Any constant quoted on this page is this edition’s.