Effective Nuclear Charge (Slater’s Rules) Calculator
Effective Nuclear Charge by Slater's Rules
Zeff = Z minus S, with the shielding constant S built the way Slater built it in 1930: 0.35 for each electron in the same group, 0.85 for each one in the shell below, 1.00 for everything deeper. Enter the counts and the page shows the arithmetic, the orbital energy it implies and the radius that goes with it.
Zeff for one electron, by Slater's rules
The 3s electron of sodium: Z = 11, n = 3, no other n = 3 electrons, eight in n = 2, two in n = 1
Z minus S, and the three numbers that make S
- Z
- the proton number. The full, unshielded pull. It never changes when the atom is ionised, which is the point most often missed when these rules are applied to an ion
- S
- the shielding or screening constant, in units of elementary charge. It is not an integer and it has no physical existence of its own: it is the number that makes a one-electron formula reproduce a many-electron atom
- 0.35
- an electron in the same group blocks about a third of a proton’s worth of pull. Slater fitted this number, along with 0.85 and 1.00, to measured atomic energies — they are not derived from anything
- 0.85
- an electron one shell in is a much better shield, because it spends most of its time between this electron and the nucleus. Not 1.00, because orbitals overlap: an outer electron does penetrate the inner shell sometimes
- the group
- Slater’s grouping is [1s] [2s 2p] [3s 3p] [3d] [4s 4p] [4d] [4f] and so on. s and p of the same n are ONE group; d and f each stand alone. That grouping is what makes the d-block behave differently from everything else on this page
Worked example
The 3s electron of sodium: Z = 11, n = 3, no other n = 3 electrons, eight in n = 2, two in n = 1
COUNT THE GROUPS. Sodium has eleven electrons: two in n = 1, eight in n = 2, and the single 3s electron we are asking about. In Slater's grouping that is [1s]² [2s 2p]&sup8; [3s]¹.
SAME GROUP. The 3s group holds only our electron, so there are no others: 0.35 × 0 = 0.
ONE SHELL BELOW. Eight electrons in n = 2, at 0.85 each: 0.85 × 8 = 6.80.
DEEPER STILL. Two electrons in n = 1, each a perfect shield: 1.00 × 2 = 2.00.
ADD AND SUBTRACT. S = 0 + 6.80 + 2.00 = 8.80, so Zeff = 11 − 8.80 = 2.20. Eleven protons, and the outermost electron feels about two of them.
CHECK IT AGAINST REALITY. Putting 2.20 into −13.6 Zeff²/n² gives −7.31 eV, so the rules predict it takes 7.31 eV to pull that electron off. Sodium's measured first ionisation energy is 5.14 eV. The estimate is 42 per cent too high — and that is the honest size of the error, worth knowing before you quote one of these numbers as though it were measured. What the rules get right is the PATTERN: sodium 2.20, magnesium 2.85, aluminium 3.50, rising 0.65 a step across the period.
AND THE TRAP. Do not count the electron you are asking about. S is what the OTHER ten electrons do; including the eleventh would give S = 9.15 and Zeff = 1.85, and the mistake is invisible because the answer still looks reasonable.
Slater’s rules in full
| The electron you are asking about | What shields it | Each one counts |
|---|---|---|
| any s or p electron | another electron in the same [ns np] group | 0.35 |
| any s or p electron | an electron in the n minus 1 shell | 0.85 |
| any s or p electron | an electron in n minus 2 or deeper | 1.00 |
| a d or an f electron | another electron in the same d or f group | 0.35 |
| a d or an f electron | every electron in any group inside it, however close | 1.00 |
| a 1s electron | the other 1s electron | 0.30 |
| any electron | itself, or anything in a group outside it | 0.00 |
Slater against the real thing, for the outermost electron
| Atom and electron | Slater Zeff | Clementi SCF Zeff | What the gap tells you |
|---|---|---|---|
| H 1s | 1.00 | 1.00 | Nothing to shield. The two methods must agree. |
| He 1s | 1.70 | 1.69 | Slater’s 0.30 was fitted on helium, so it is nearly exact here. |
| Li 2s | 1.30 | 1.28 | Good. A single valence electron outside a filled shell is the easy case. |
| C 2p | 3.25 | 3.14 | Slater is 3 per cent high; the trend across the period is still right. |
| F 2p | 5.20 | 5.10 | Still close. The 0.65 per step rise is real and both methods show it. |
| Na 3s | 2.20 | 2.51 | Slater is 12 per cent LOW here: the 0.85 figure over-credits the n = 2 shell. |
| K 4s | 2.20 | 3.50 | The worst case on this page. Slater has potassium identical to sodium; the real value is 60 per cent higher. |
Why eleven protons pull like two
A sodium atom has eleven protons. Its outermost electron behaves as though there were about two. The other ten electrons sit between it and the nucleus and cancel most of the pull, and the leftover is called the effective nuclear charge, Zeff. It is the single idea behind every trend in the periodic table that a school course asks you to explain.
The trouble is that shielding is not a tidy quantity. Electrons are not shells of paint; an outer electron spends some of its time inside the inner ones, and an inner electron is not always between you and the nucleus. There is no exact formula. What John Slater did in 1930 was fit a set of numbers that reproduce measured atomic energies well enough to be useful: 0.35 for a neighbour in the same group, 0.85 for one in the shell below, 1.00 for anything deeper, and 0.30 for the partner of a 1s electron. That is the whole method, and it is entirely arithmetic.
Two patterns fall straight out of it. ACROSS a period, each step adds one proton and one electron, but the new electron joins the same group and shields only 0.35 of the new proton. Zeff therefore climbs by 0.65 per step: carbon 3.25, nitrogen 3.90, oxygen 4.55, fluorine 5.20. Atoms get smaller and ionisation energy rises, and now you can say why with a number rather than a hand-wave. DOWN a group, the added electrons go into a new shell and the old shell shields 0.85 or 1.00 of the added protons, so Zeff hardly moves at all. Slater has sodium and potassium both at exactly 2.20.
That last result is also where the rules visibly break. Potassium’s real effective charge, from self-consistent-field calculations, is about 3.50, not 2.20 — sixty per cent higher. The rules were fitted to the first two periods and they get steadily worse below them. They are a teaching device with a known failure mode, and a page that printed 2.20 without saying so would be giving you a number to quote rather than a method to understand.
The energy estimate below the headline has the same character. Feeding Zeff into the one-electron energy formula gives sodium 7.31 eV against a measured 5.14 eV. It is the right order and the wrong value, which is what an empirical shielding constant bolted onto a one-electron model should be expected to produce. The one-electron model itself belongs to physics: see the Bohr model energy level calculator for where the 13.6 eV comes from, and the photon energy calculator for turning an energy gap into a wavelength. On this site the measured side of the story is the ionisation energy and periodic trends page, which works from real successive ionisation energies instead of from a model.
One thing this page deliberately does not do: it will not give you an electron configuration. The calculator is numeric from end to end — it takes counts and returns charges and energies — so you have to work out the configuration yourself and type the counts in. That is not a limitation worth hiding, and counting the groups by hand is most of the learning anyway.
Frequently asked questions
What is the effective nuclear charge of sodium?
For its outermost 3s electron, Slater’s rules give Zeff = 11 − 8.80 = 2.20. The shielding constant 8.80 is eight n = 2 electrons at 0.85 plus two n = 1 electrons at 1.00. A sodium 2p electron is a different question with a different answer: there the shielding is 0.35 × 7 + 0.85 × 2 = 4.15, so Zeff = 6.85. Always say which electron you mean.
Do I count the electron I am asking about?
No, never. S measures what the OTHER electrons do to this one. Including it is the commonest error in this calculation and it is invisible, because the answer still looks plausible — for sodium it would give 1.85 instead of 2.20.
Why do d electrons get shielded 1.00 by everything inside them?
Because a d orbital is poor at penetrating the inner shells. An s electron has a real chance of being found close to the nucleus, inside the core, so the core shields it imperfectly; a d electron essentially never gets in there, so the core shields it almost perfectly. That one asymmetry is why, in a transition metal, the 4s electrons are removed before the 3d ones even though 4s fills first: by the time the d shell is occupied, the 3d electrons feel a much larger Zeff than the 4s electrons do. For zinc this page gives 8.85 against 4.35.
How accurate are Slater’s rules?
Good to a few per cent for the first two periods and increasingly poor below them. Against Clementi and Raimondi’s self-consistent-field values, carbon 2p is 3 per cent high, sodium 3s is 12 per cent low and potassium 4s is 37 per cent low. Use them for the trend, not for the number, and say which set you used if you quote one.
Does Zeff change when an atom becomes an ion?
Z does not — the nucleus is untouched — but S does, because electrons have left or arrived. Sodium’s 2p electron has Zeff = 6.85 in the neutral atom; in Na⁺ the 3s electron is gone, but it was outside the 2p group and so shielded it by 0.00 anyway, and the 2p Zeff is unchanged at 6.85. For an anion the extra electron joins a group and does shield: chloride’s 3p electrons feel 0.35 less than chlorine’s.
Is Zeff the same as electronegativity?
No, but they are closely related, and Allred and Rochow’s electronegativity scale is literally built from Zeff: they defined it as 0.359 Zeff/r² + 0.744, with r the covalent radius. So an effective nuclear charge is one of the ingredients of an electronegativity rather than a synonym for it.
Related calculators
References
- J. C. Slater, “Atomic Shielding Constants”, Physical Review 36 (1930) 57–64. The original paper, and worth knowing what it actually claims: Slater is explicit that the constants are chosen to fit measured atomic energies and X-ray levels, not derived. The grouping of s and p together while d and f stand alone is his, and so is the 0.30 for the 1s pair, which he fitted to helium.
- E. Clementi and D. L. Raimondi, “Atomic Screening Constants from SCF Functions”, Journal of Chemical Physics 38 (1963) 2686–2689, extended to Z = 86 by Clementi, Raimondi and Reinhardt in 47 (1967) 1300. The reference values the second table compares against. They are fitted to self-consistent-field wavefunctions rather than to measured energies, and they are where the honest statement that Slater’s rules fail for potassium comes from.
- NIST Atomic Spectra Database, version 5.11, ionisation-energy tables, National Institute of Standards and Technology, read 14 November 2026. The primary source for ionisation energies, which it publishes in electronvolts per atom from measured spectra. The kilojoules per mole printed in a school data book are those values multiplied by the Faraday constant and rounded, so the two never disagree by more than the rounding.
- P. Atkins, T. Overton, J. Rourke, M. Weller and F. Armstrong, Shriver and Atkins’ Inorganic Chemistry, 5th edition, Oxford University Press, 2010, chapter 1. The standard undergraduate treatment of Slater shielding, penetration and the resulting periodic trends, including the penetration argument for why an s electron is shielded less than a p electron of the same shell — a refinement Slater’s rules deliberately ignore by putting s and p in one group.
