Degree of Dissociation and Ostwald’s Dilution Law
Degree of dissociation α, Ostwald's dilution law, and why dilution sets a weak acid free
Give it Ka and a concentration and it solves Ka = cα2/(1 − α) properly, with the quadratic rather than the shortcut — then shows you what the shortcut would have said, how far out it is, and what happens to α when you dilute the solution.
α from Ka and concentration
acetic acid, Ka = 1.8 × 10⁻⁵, made up at 0.1 mol/L and then diluted tenfold
Ostwald’s dilution law, solved properly
- α
- the degree of dissociation: the fraction of the acid that has come apart, between 0 and 1. Multiply by 100 for the percentage the headline shows. It is a property of the solution, not of the acid alone, because it depends on the concentration
- c
- the concentration as made up, before any dissociation. At equilibrium the undissociated acid is c(1 − α) and each ion is cα, which is where the whole law comes from
- 1 − α
- the term the shortcut throws away. Keeping it turns the equation into a quadratic; throwing it away turns it into a square root. The five per cent rule is simply the point at which throwing it away stops being honest
- Ka
- the acid dissociation constant, fixed by the acid and the temperature. It does NOT change when you dilute — α does, and that is the entire surprise of Ostwald’s law
- pH = −log10[H+]
- a base-ten logarithm, never a natural one. The two differ by a factor of 2.303, which is more than enough to turn a right answer into a plausible wrong one
Worked example
acetic acid, Ka = 1.8 × 10⁻⁵, made up at 0.1 mol/L and then diluted tenfold
WRITE THE EQUILIBRIUM ROW FIRST, which is where the law comes from. Start with c of the acid and nothing else. A fraction α comes apart, so at equilibrium there is c(1 − α) of the acid and cα of each ion. Put those into Ka = [H+][A−]/[HA] and the cα terms multiply to give Ka = cα2/(1 − α)
SOLVE IT AS A QUADRATIC, because that is what it is. Rearranged: cα2 + Kaα − Ka = 0, so α = (−Ka + √(Ka2 + 4Kac))/2c. With Ka = 1.8 × 10−5 and c = 0.1: the discriminant is 3.24 × 10−10 + 7.2 × 10−6 = 7.200324 × 10−6, whose root is 2.683343 × 10−3. Then α = (2.683343 × 10−3 − 1.8 × 10−5)/0.2 = 0.0133267, which is 1.3327 per cent
NOW THE SHORTCUT, FOR COMPARISON. √(Ka/c) = √(1.8 × 10−4) = 0.0134164, or 1.3416 per cent. It is 0.67 per cent too high — and since α itself is 1.33 per cent, comfortably under five, that is exactly what the rule predicts. The shortcut was safe here, and the page says so
GET THE pH FROM α, NOT FROM c. [H+] = cα = 0.1 × 0.0133267 = 1.33267 × 10−3 mol L−1. pH = −log10(1.33267 × 10−3) = 2.8753. Use a natural logarithm by mistake and you get 6.62, which is not a typing error you would notice
DILUTE TENFOLD AND WATCH α GO UP. c becomes 0.01, and the same quadratic now gives α = 0.0415360, or 4.1536 per cent. The acid is three times more dissociated than it was, in a solution three times weaker. The ratio is 4.1536/1.3327 = 3.1167, against √10 = 3.1623 — close, because the shortcut says α goes as 1/√c, and not identical, because the shortcut is still a shortcut
AND CHECK THE pH DID THE OPPOSITE. [H+] = 0.01 × 0.0415360 = 4.1536 × 10−4, so pH = 3.3816. Diluting tenfold moved the pH by only 0.506, not by a whole unit, because the acid released more of its store as you diluted it. That partial resistance to dilution is the same effect that makes a weak acid and its salt into a buffer
Acetic acid at six concentrations: Ka fixed, α anything but
| Concentration, mol/L | α exact, % | α from √(Ka/c), % | Shortcut is out by | [H⁺], mol/L | pH |
|---|---|---|---|---|---|
| 1.0 | 0.4234 | 0.4243 | 0.21% | 4.234 × 10⁻³ | 2.373 |
| 0.1 | 1.3327 | 1.3416 | 0.67% | 1.333 × 10⁻³ | 2.875 |
| 0.01 | 4.1536 | 4.2426 | 2.14% | 4.154 × 10⁻⁴ | 3.382 |
| 0.001 | 12.547 | 13.416 | 6.93% | 1.255 × 10⁻⁴ | 3.901 |
| 0.0001 | 34.371 | 42.426 | 23.4% | 3.437 × 10⁻⁵ | 4.464 |
| 0.00001 | 71.555 | 134.16 | 87.5% | 7.155 × 10⁻⁶ | 5.145 |
Why diluting a weak acid makes more of it come apart
The surprise in Ostwald’s law is that dilution works the wrong way round. Add water to a weak acid and you have fewer acid molecules per litre, so you might expect fewer hydrogen ions and a less complete dissociation. The second half of that is wrong. The FRACTION that dissociates goes UP as you dilute, and it keeps going up towards 1. The NIOS lesson states it directly: at fixed temperature α is inversely proportional to the square root of the concentration.
The reason is in the shape of the equilibrium, not in any special property of acids. Dissociation turns one particle into two, so it is a reaction with more particles on the product side. Diluting is the solution-phase version of letting a gas expand, and an equilibrium with more particles on the right responds to expansion by moving right — which is Le Chatelier’s principle applied to a solvent. Seen that way, Ostwald’s law is not a separate thing to learn but the dilution entry in that same table.
What does NOT change is Ka, and this is the distinction worth guarding. Ka belongs to the acid and the temperature. α belongs to the solution. Dilute and Ka sits still while α climbs and [H+] falls — all three at once, which is why the pH moves by less than a whole unit for a tenfold dilution even though the concentration has fallen by a factor of ten. A student who reports that Ka changed on dilution has confused the constant with the fraction.
The shortcut is useful and it fails loudly, which is the best combination. Taking 1 − α as 1 gives α = √(Ka/c), an answer you can get in one step. It is excellent while α is small and it degrades fast: in the table above it returns 134 per cent dissociation for a very dilute solution, which is not merely inaccurate but impossible. The test is the five per cent rule — work out α, and if it is under five per cent the neglected term was smaller than ordinary experimental error. The cheaper test, before you do any algebra at all, is the ratio c/Ka: above a thousand and the shortcut is safe, below a hundred and it is not. Both are printed above.
Two limits this page does not cross, said plainly. It assumes the acid is the only source of hydrogen ions, which stops being true below about 10−6 mol L−1 where water’s own ionisation takes over — the page warns you when the resulting pH comes out above 7, which is the point at which the answer has become visibly absurd rather than quietly wrong. And it assumes one ionisable proton: for a diprotic acid the first dissociation usually dominates, so the answer here is a good first approximation, but the second constant is not in it. For buffers, which are this equilibrium with its product already present, see the buffer pH from pKa calculator and the Henderson-Hasselbalch calculator in the medical plugin in the medical plugin; this page does not duplicate them.
Frequently asked questions
Why does α go up when I dilute, if there is less acid?
Because α is a fraction, not an amount. There are fewer hydrogen ions per litre after dilution — [H+] genuinely falls and the pH genuinely rises — but a LARGER SHARE of the acid that is present has come apart. Both statements are in the rows above at once. The mechanism is that dissociation makes two particles out of one, so spreading the solution out favours it, exactly as expanding a vessel favours the side of a gas equilibrium with more molecules.
When is α = √(Ka/c) good enough?
When the answer comes out under about five per cent, which is the rule the UCalgary text gives, on the ground that ordinary experimental error is about five per cent anyway. There is also a cheaper test you can do first: if the concentration is more than a thousand times Ka the shortcut is likely safe, between a hundred and a thousand you should solve and then check, and below a hundred you should go straight to the quadratic. This page prints both the exact root and the shortcut’s answer side by side with the gap between them, so you can stop guessing.
Can I use this for a weak base?
Yes, with one translation. Enter Kb in the Ka box and the algebra is identical, because Ostwald’s law is about a weak ELECTROLYTE and does not care whether the ion released is H+ or OH−. Then read the [H+] row as [OH−] and the pH row as pOH, and get the pH from pH = 14 − pOH at 25 °C. The NIOS lesson’s own worked example is a base, ammonium hydroxide, and it comes out at α = 0.134 at 0.001 mol L−1 — which is 13 per cent and well past the five per cent window, a useful reminder that the shortcut is not a default.
The pH I get is above 7 for an acid. What went wrong?
The model, not the arithmetic. This calculation counts only the hydrogen ions the acid released and ignores the 10−7 mol L−1 that pure water supplies. For an acid more dilute than about 10−6 mol L−1 the water is the bigger contributor, so counting only the acid gives a figure that drifts past 7 and keeps going, which no acid ever does. The degree of dissociation above is still meaningful at that dilution; the pH is not, and the page says so when it happens.
Does this work for a strong acid?
No, and it is not meant to. A strong acid dissociates completely, so α is 1 by definition and there is no equilibrium to solve — the hydrogen ion concentration is simply the concentration you made up. Ostwald’s law applies to weak electrolytes, and the giveaway that you are outside its range is an answer near 100 per cent, which is why the top band on the gauge says so rather than reporting a number as though it meant something.
Related calculators
References
- National Institute of Open Schooling, senior secondary Chemistry (course 313), Module 5 “Chemical Dynamics”, Lesson 12, “Ionic Equilibrium”, read from the NIOS digital repository on 14 November 2026. The source of Ostwald’s dilution law as this batch states it: for a weak electrolyte of initial concentration c and degree of dissociation α, the equilibrium amounts are c(1 − α) undissociated and cα of each ion, so K = cα2/(1 − α); the lesson then takes 1 − α as approximately 1 for a weak electrolyte to get α = √(K/c), says that α is inversely proportional to the square root of the concentration at fixed temperature, and states the conclusion directly — α increases on dilution. Its own worked example is a check on the approximation rather than a licence for it: ammonium hydroxide at 0.001 mol L−1 comes out at α = 0.134, which is 13 per cent and far outside the five per cent window. The same lesson gives Ka = 1.8 × 10−5 for acetic acid in section 12.4.1, uses 1.85 × 10−5 in a later example of its own, and quotes pKa = 4.73 in example 12.9 — three figures for one acid in one document, which is why this page asks you for Ka instead of choosing one for you.
- Equilibrium Calculations: The “Small-X” Assumption, UCalgary Chemistry Textbook (Chemistry Open Textbook, version 2), adapted from OpenStax Chemistry 2e under CC BY 4.0 and credited to E. Sullivan and A. Musgrove of the University of Calgary with E. Merschrod of Memorial University (read 14 November 2026). The source of the two tests this batch prints. The five per cent rule: the assumption that the change x can be dropped from a starting concentration is acceptable when x is less than about five per cent of that concentration, the page’s stated reason being that ordinary experimental error is itself about five per cent, so a change below that level adds little uncertainty. And the pre-check before you solve anything: a starting concentration more than a thousand times K makes the shortcut likely safe, a ratio between a hundred and a thousand needs the check afterwards, and a ratio below a hundred usually calls for the quadratic formula. The page’s instruction when the check fails is to redo the calculation with the quadratic rather than to patch the approximate answer.
- W. R. Robinson and others, Chemistry 2e, OpenStax, section 13.2, “Equilibrium Constants”, revision of 14 February 2019 (read 14 November 2026). Read for the comparison with the Indian school treatment, and the two differ in a way worth knowing. OpenStax gives the Q against K rules in the same three cases — Q below K and the net reaction runs forward, Q above K and it runs in reverse, Q equal to K and the system is at equilibrium — but it assigns no units at all to Q or K, stating that the rigorous expressions use relative, dimensionless concentrations and pressures, and that disregarding units in an introductory course introduces only modest error. It also declines to put any numeric threshold on “large” or “small” K, saying only that a large K means most of the reactant has been converted by the time equilibrium is reached, and warning in the same section that K says nothing whatever about RATE: some of these equilibria arrive in milliseconds and some take years.
- COULD NOT BE READ, and nothing was substituted. The NCERT textbook PDFs on ncert.nic.in were not retrievable on 14 November 2026, so the NCERT material above is cited through the IIT Kanpur republication actually read rather than by textbook page number. Everything this page asserts about catalysts and about an inert gas at constant volume comes from that republication’s own words and table, quoted in the reference above.
